Table of Contents

Safety Leaflet: Anycubic Mono X Resin 3D Printer

Introduction:

The Anycubic Mono X Resin 3D Printer is an advanced device designed for high-resolution resin printing. To ensure a safe and efficient working environment, it's crucial to adhere to the following safety guidelines.

Operating Environment:

  1. Resin Handling: Use gloves when handling resin cartridges and other consumables.
  2. Ventilation: Operate the printer in a well-ventilated area or use an appropriate fume extraction system.

Personal Protective Equipment (PPE):

  1. Gloves: Wear nitrile gloves when handling resin and cleaning the printer.
  2. Face Mask: Wear a mask over nose and mouth (FFP2 or better preferred) when handling resin and cleaning the printer.
  3. Protective Eyewear: Recommended: Wear protective goggles to shield your eyes from resin splashes.

General Safety:

  1. Supervision: Do not leave the resin printer unattended during operation.
  2. Emergency Stop: Familiarize yourself with the emergency stop button. Press it in case of any issues.
  3. Training: Only trained personnel should operate the resin printer. Seek assistance if needed.

Maintenance and Care:

  1. Resin Spills: Clean resin spills immediately using the provided cleaning materials.
  2. Cleaning: Keep the printer clean from resin residue. Follow recommended cleaning procedures.

Emergency Procedures:

  1. Injuries: In case of injuries, seek medical attention immediately.
  2. Resin Exposure: If resin comes into contact with your skin or eyes, rinse thoroughly with water and seek medical attention.

Additional Resources:

  1. Manual: Refer to the printer manual for detailed instructions and safety guidelines.
  2. Training: Attend training sessions to enhance your understanding of safe printer operation.

Contact Information:

For any questions or concerns, contact [Your Workshop Contact Information].

Note: This safety leaflet is a guide. Always follow the manufacturer's instructions and guidelines. Your safety is our priority.